Screen: 7.3.0.0 (Com Filters) - RMG EC 900 Operating Instructions Manual

..........................................................................................................................................................................................................
IMPORTANT:
The factory settings of this interface must not be changed for the device types EC 912 and EC 922!

Screen: 7.3.0.0 (Com filters)

F reg1
F reg2
F reg3
F reg4
F reg5
F reg6
F reg7
F reg8
F reg9
F reg10
F reg11
F reg12
F reg13
F reg14
F reg15
F reg16
F reg17
F reg18
<COMM OUTPUTS CU >
The filters are designed for a future functionality and are not yet supported.
Screen: 7.4.0.0 (Status display of important CU parameters)
>CUS
>Signal
>Login
>Pin
>Connect
>Mod fault
>RS232 fault
>RS4xx fault
>Net fault
>ISB fault
>CUC
>CUTS
CUCommand
CUComP1
CUComP2
CUComP3
CUComP4
>CUD
<COMM OUTPUTS CU>
..........................................................................................................................................................................................................
0 Transfer filter 1
0 Transfer filter 2
0 Transfer filter 3
0 Transfer filter 4
0 Transfer filter 5
0 Transfer filter 6
0 Transfer filter 7
0 Transfer filter 8
0 Transfer filter 9
0 Transfer filter 10
0 Transfer filter 11
0 Transfer filter 12
0 Transfer filter 13
Transfer filter 14
0
0 Transfer filter 15
0 Transfer filter 16
0 Transfer filter 17
0 Transfer filter 18
"COMM" book
00000000 Status display of the CU communication (8 digits)
00000 Strength of the radio signal
-0000 Login status with built-in GSM/GPRS modem
00000 PIN status with built-in GSM/GPRS modem
00000 Number of successful transmissions
0000 Number of module faults for the installed module (e.g. GSM)
0000 Counts the faults in the scope of a RS 232/USB connection
0000 Counts the faults in the scope of a RS 422/485 connection
0000 Counts the faults in the scope of a Ethernet connection
0000 Counts the protocol faults in the ISB, registered by the CU
D0000000 CUC
00000 CUTS
00000 Command for parameter changes of the int. or ext. CU
00000 Command parameter 1, passed to the CU
00000 Command parameter 2, passed to the CU
00000 Command parameter 3, passed to the CU
00000 Command parameter 4, passed to the CU
Display of data retrieved via CU command
"COMM" book
OPERATION
95