..........................................................................................................................................................................................................
Screen: 8.1.6.2 (digital output 6 – parameters)
DA6 src
DA6 type
DA6 min
DA6 max
DA6 test
<OUTPUTS CU
In order to test the static outputs, first set DA6 type mode at "Off". Via DA6 test mode, you can
then set the output at "Low" or "High". Afterwards, the signal status will be shown in field DA6 set
(screen 8.1.6.1).
Screen: 8.2.0.0 (analogue outputs)
+Analogue output 1
+Analogue output 2
+Analogue output 3
+Analogue output 4
<OUTPUTS CU
The analogue outputs can only be used in conjunction with the external CU 900 communication
unit.
Screen: 8.2.1.0 (analogue output 1)
+Display values
+Parameters
<OUTPUTS CU
Screen: 8.2.1.1 (analogue output 1 - display values)
>A1 phys
>A1 mA
<OUTPUTS CU
..........................................................................................................................................................................................................
K coeff.
Selection of the source for digital output 6 {Pres-
sure|Temperat.|Conv. fact.|K coeff.| Flow|Flow bcond|Input
6|Input 7|Input 8}
Mi/Ma. co.
Selection of the type of digital output 6 {Off|Day max.|Alarm
co.|Warn co.|C sw. code|Mains|Min cont.|Max cont.|Mi/Ma.
co.|In to Out}
0.500
Minimum limit
1.500
Maximum limit
Low
Test of signal output {Low|High}
>
"OUTPUTS" book
Press Enter to go to screen 8.2.1.0
Press Enter to go to screen 8.2.2.0
Press Enter to go to screen 8.2.3.0
Press Enter to go to screen 8.2.4.0
>
"OUTPUTS" book
Press Enter to go to screen 8.2.1.1
Press Enter to go to screen 8.2.1.2
>
"OUTPUTS" book
0.000
Analogue output 1, physical value
4.000 mA
Analogue output 1, current (mA)
>
"OUTPUTS" book
OPERATION
103