RMG EC 900 Operating Instructions Manual page 55

..........................................................................................................................................................................................................
All entries will be recorded in the parameter logbook and, if appropriate, also in the legal metrologi-
cal logbook.
The way of how to proceed in order to display or change parameters which is described above by
the example of pressure parameters can basically be applied to all the other books as well.
..........................................................................................................................................................................................................
10. On the Modes of operation screen, you can set the
unit and operating mode of the pressure transmitter.
Press " " and Enter to access the following input
mask:
11. In this mask, press " " or " " to browse through fixed
texts for selection. Press Enter to complete your en-
try and save the new operating mode which will then
appear in line 1.
12. In the "Measured values" chapter for pressure, press
Enter to access the display screen where additional
measured or calculated values will be displayed.
OPERATION
47