Screen: 8.1.2.1 (Digital Output 2 – Display Values) - RMG EC 900 Operating Instructions Manual

OPERATION
..........................................................................................................................................................................................................
Screen: 8.1.2.1 (digital output 2 – display values)
>DA2 set
>DA2 act
>DA2 freq
<OUTPUTS CU
100
Screen: 8.1.2.2 (digital output 2 – parameters)
DA2 src
DA2 type
DA2 sfac
DA2 pulse
DA2 ipp
DA2 HF
DA2 test
<OUTPUTS CU
Through the DA2 test parameter, you can set a number of pulses which will then have to be output-
ted. The number of pulses outputted will be shown in field DA2 act (screen 8.1.2.1).
"Dispat. LF CU" under DA2 type means that pulse output 2 is switched off. The value selected un-
der DA2 src is digitally transmitted to the CU 900 from where it is outputted via pulse output 2.
NOTE: It is possible that delays occur. As a result, pulse output 2 of the CU 900 can no longer be
used as digital output 4 of the EC 900.
Screen: 8.1.3.0 (digital output 3)
+Display values
+Parameters
<OUTPUTS CU
Screen: 8.1.3.1 (digital output 3 – display values)
>DA3 set
<OUTPUTS CU
..........................................................................................................................................................................................................
0 Counter for spec. output pulses (no. of pulses to be outputted)
0 Counter for actual output pulses (number of pulses outputted)
0.000 Hz Current frequency of output pulses
> "OUTPUTS" book
Vb Selection of the source for digital output 2
{Vm|Vb|Vo|Flow|Flow bcond}
Dispat. LF Selection of the type of digital output 2
{Off|Tot. LF|Dispat. LF|Dispat. LF CU|Dispat. HF}
1.000000 Scaling factor for the type of pulse output
50 ms Selection of the pulse duration for LF pulse output {10ms|
25ms|50ms|75ms|100ms|150ms|200ms|250ms|500ms}
50 ms Selection of the interpulse period for LF pulse output {10ms|
25ms|50ms|75ms|100ms|150ms|200ms|250ms|500ms}
0.1 ms Selection {0.05 ms|0.1 ms|0.2 ms|0.5 ms|1.0 ms}
0 Test of output pulses (only if DA2 type = Tot. LF)
> "OUTPUTS" book
Press Enter to go to screen 8.1.3.1
Press Enter to go to screen 8.1.3.2
>
"OUTPUTS" book
0 Status of the output contact
> "OUTPUTS" book