Screen: 2.2.2.0 (Temperature Limits); Screen: 2.2.3.0 (Temperature Default); Screen: 2.2.4.0 (Temperature Parameters); Screen: 2.2.5.0 (Temperature Modes) - RMG EC 900 Operating Instructions Manual

OPERATION
..........................................................................................................................................................................................................

Screen: 2.2.2.0 (temperature limits)

tmin
tmax
<PTZ OPER. TARIFF>

Screen: 2.2.3.0 (temperature default)

66
tdef
<PTZ OPER. TARIFF>

Screen: 2.2.4.0 (temperature parameters)

toffs 0.000
<PTZ OPER. TARIFF>

Screen: 2.2.5.0 (temperature modes)

tunit
tmode
<PTZ OPER. TARIFF>
Note: The "4-20mA" mode is currently not yet available; in these cases, the default value will be
used.
In "Calibrate" mode, the last measured value is frozen and used for further calculations. During this
time, a calibration device can be connected and the value measured by this device will be shown in
field tC (see screen 2.2.1.0). Now the adjustment parameters can be adjusted. Such adjustment is
not permissible for custody transfer metering.

Screen: 2.3.0.0 (compressibility factor)

+Measured values
+Default values
+Parameters
+Modes of operation
<PTZ OPER. TARIFF>
..........................................................................................................................................................................................................
-20.00 °C Lower alarm limit for temperature
60.00 °C Upper alarm limit for temperature
"PTZ" book
10.00 °C Replacement value for temperature
"PTZ" book
Temperature offset
"PTZ" book
Selection of the unit for temperature {°C|°F|K}
Selection of the temperature mode
{PT1000|4-20mA|Default|Calibrate}
"PTZ" book
Press Enter to go to screen 2.3.1.0
Press Enter to go to screen 2.3.2.0
Press Enter to go to screen 2.3.3.0
Press Enter to go to screen 2.3.4.0
"PTZ" book