Changing Parameters; Examples Of Programming - RMG EC 900 Operating Instructions Manual

..........................................................................................................................................................................................................

Changing parameters

Follow the steps below in order to change a parameter:
1. In the menu, go to the desired parameter so that the cursor is located in front of the name of
the parameter.
2. Press Enter. The cursor (underscore) is now located below the first digit of the number.
3. Press the " " or " " key to increase or decrease this digit by 1. You can also select the ".", "-"
and "E" (exponent) characters.
4. Then press " " to jump to the next position.
5. After you have changed the last position, press Enter (or " " in the case of codes) to terminate
your programming.
If you want to change an operating mode instead of a parameter, you have to proceed in the same
way. Instead of changing a digital place, press " " or " " to browse through the individual operating
modes.

Examples of programming

The following examples describe frequent or less frequent but important programming work on the
EC 900. In these examples (with the exception of the first one), it is assumed that the code has
already been entered.
The examples start with the customized display screen. Usually, the cursor is located somewhere in
the menu. Press Esc more than once to reach the start window in the "CUSTOMIZED DISPLAY"
book.
..........................................................................................................................................................................................................
OPERATION
41