Chrysler Sebring 2004 Service Manual page 3393

TRANSMISSION - NGC
P1684-BATTERY WAS DISCONNECTED —
TEST
2 Has the battery been disconnected, lost it's charge, or been replaced recently?
Yes → Disconnecting or replacing the battery will set this DTC. Erase
→ Go To 3
No
3 Has a Quick Learn procedure been performed?
Yes → Performing Quick Learn will set this DTC. Erase the DTC.
→ Go To 4
No
4 Has the PCM been replaced or disconnected?
Yes → Replacing or disconnecting the PCM will set this DTC. Erase the
→ Go To 5
No
5 Turn the ignition off to the lock position.
Disconnect the PCM harness connector.
Note: Check connectors - Clean/repair as necessary.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Using a 12-volt test light connected to ground, check the Fused B+ circuit.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?
Yes → Go To 6
→ Repair the Fused B+ circuit for an open. If the fuse is open make
No
ACTION
the DTC.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
DTC.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
sure to check for a short to ground.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Continued
286
APPLICABILITY
All
All
All
All