Chrysler Sebring 2004 Service Manual page 3479

BRAKES (CAB)
PUMP CIRCUIT FAILURE —
TEST
11 Turn the ignition off.
Disconnect the ABS Pump Motor connector.
Check connectors - Clean/repair as necessary.
Connect a 10 gauge 40 amp fused jumper wire between the ABS Pump Fused B(+)
terminal in the CAB harness connector to the ABS Pump Motor connector RED wired
terminal.
Connect a 10 gauge jumper wire between the ABS Pump Motor connector BLACK
wired terminal and ground.
Did the ABS Pump Motor operate?
Yes → Repair the ABS Pump Motor Fused B(+) circuit for an open.
→ Repair the ABS Pump Motor Ground circuit for an open.
No
Continued
ACTION
Perform ABS VERIFICATION TEST - VER 1.
Perform ABS VERIFICATION TEST - VER 1.
28
APPLICABILITY
All