Chrysler Sebring 2004 Service Manual page 3462

BUS SYSTEM COMMUNICATION FAILURE —
TEST
3 Turn the ignition off.
Disconnect the negative (-) battery cable.
Disconnect the CAB harness connector.
NOTE: check connector - Clean/repair as necessary.
Measure the resistance of the Bus circuit between the CAB connector and the Data
Link Connector (DLC).
Is the resistance below 5.0 ohms?
Yes → Replace the Controller Antilock Brake in accordance with the
No
4 Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any problems found?
Yes → Repair as necessary.
No
ACTION
Service Information.
Perform ABS VERIFICATION TEST - VER 1.
→ Repair the Bus circuit for an open.
Perform ABS VERIFICATION TEST - VER 1.
Perform ABS VERIFICATION TEST - VER 1.
→ Test Complete.
Continued
11
BRAKES (CAB)
APPLICABILITY
All
All