Table of Contents
Advertisement
03-32
Room lamp OFF control
▶
1.
The room lamps stop operating when the BCM enters into the theft deterrent or sleep mode.
(This is to prevent battery discharge if the overhead room lamp and sensor room lamp switch is
ON position.)
2.
The room lamps go off automatically 10 minutes after the key is removed. After that, if the door
unlock or all door open signal is received and the key is inserted, the sleep mode is deactivated
and the room lamps operate for another 10 minutes.
3.
The room lamps come on when the key is inserted (BCM without SKM) or the ignition switch is
turned to "ACC" or "ON" position (BCM with SKM) while the room lamps are OFF.
8) Key Hole Illumination
1.
When opening the door with IGN OFF, the key hole lamp comes on.
When closing the door, the key hole lamp stays on for 10 seconds and goes off.
2.
When turning the ignition switch to ON position during the operation of key hole illumination, it
goes off immediately.
3.
When receiving the door lock signal (entering into theft deterrent mode), the lamp goes off.
4.
The key hole illumination function has a priority over the immobilizer function.
5.
If the communication with the immobilizer is interrupted, the lamp comes on for 11 seconds
with the interval of 0.5s ON/0.5s OFF regardless of the operating conditions of key hole lamp.
6.
When turning the ignition switch to ON position in "Virgin" condition, the lamp comes on for 8
seconds with the interval of 0.5s ON/0.5s OFF.
(*1) ON: IGN ON
OFF: IGN OFF
(*2) Open: driver or passenger door is open
Close: driver and passenger door are closed
Hide quick links:
Advertisement
Chapters
Table of Contents
