SSANGYONG Korando 2012 Manual page 782

07-10
(5) Auto light (LIN)
Auto light switch Automatic light sensor unit
The auto light sensor unit is installed to the back side of the ECM mirror located upper center of
the windshield, and detects the illuminance change. The BCM communicates with the auto light
sensor when the ignition is turned on, and turns on or off the tail lamp and headlamp
automatically according to the signals from the sensor when the multifunction switch is set to
AUTO light.
The BCM communicates with the rain sensor even if the multifunction switch is in tail lamp.
(6) Side repeater lamp
Side repeater lamp
The side repeater lamp is operated by the BCM when the BCM receives a signal from the
multifunction switch.
The BCM cycles the side repeater lamp and buzzer (ON/OFF) 75 times per minute.
The side repeater lamp operates only when IGN1 is ON.
If the side repeater lamp fails while it is illuminated, the BCM cycles the lamp and buzzer 100 times
per minute.
The lamp automatically flashes 3 times when the multifunction switch is turned on. If the switch is
turned off
during this operation, the lamp flashes 3 times and then goes off.
If the switch is turned off and then on during the 3 times of automatic flashing, the lamp flashes 3
more times.