▶
How to remove the injector for Euro-V
1.
Set up the injector remover assembly on
four cylinder head bolts.
-
Pay attention not to damage the other
components when installing the main bar
assembly.
-
Before setting up the injector remover,
check if the cylinder head bolts have
been tightened with the specified
tightening torque.
The sub supports should be positioned on
the cylinder head cover bolts.
2.
Tighten the support mounting bolts (A) and
the bar holder bolts (B) completely.
3.
Install the main bolt holder.
Align the slot on main bolt with the main
bolt holder tab.
01-19
0000-00