SSANGYONG Korando 2012 Manual page 781

(4) Turn signal lamp / Side repeater lamp
▶ Front
▶ Rear
The turn signal lamp is operated by the BCM when the BCM receives a signal from the
multifunction switch. The BCM cycles the turn signal lamp and buzzer (ON/OFF) 75 times per
minute.
The turn signal lamps are operational only when IGN1 is ON.
If the turn signal lamp fails while it is illuminated, the BCM cycles the lamp and buzzer 100 times
per minute.
The BCM determines that there is an open circuit if the load is 3.0 A or less, and there is a short
circuit if the load is 7.0 A or more.
When turning ON the turn signal switch, the lamp blinks 3 times by the BCM. When turning OFF
the switch during the operation, the turn signal lamp blinks 3 times and goes off.
When turning OFF and then immediately ON the turn signal switch during auto blinking operation
of 3 times, the turn signal lamp blinks additional 3 times.
If one of the turn signal lamp is flashing and the other lamp switch is turned on, the lamp for the
activated switch flashes.
Turn signal lamp
Turn signal lamp
07-9
8310-00