SSANGYONG Korando 2012 Manual page 584

5) Seat Belt
▶ Seat belt warning
1. When turning the ignition switch (IGN1) to ON from OFF position, the BCM sends the driver and
front passenger seat belt warning signals to the instrument cluster module through the CAN
communication, and the buzzer sounds for 0.6 seconds with the interval of 0.02 s ON and 1.38
s OFF. If the driver/passenger seat belts are fastened, the buzzer does not sound but the
warning lamp blinks during the period. (the buzzer is controlled by BCM and the warning lamp
is controlled by ICM)
For the passenger seat, however, the system detects if the passenger seat is empty or
occupied and operates the warning lamp only for the first time.
After that, the only seat belt reminder detects if the passenger seat is occupied.
For the driver seat, the seat belt reminder operates only when the seat belt is not fastened at
the vehicle speed of 25 km/h or higher.
2. The instrument cluster module controls the driver/passenger seat belt warning lamps by
receiving the driver/passenger seat belt warning lamp signals.
3. When turning the ignition switch (IGN1) to OFF position during the warning operation, the
buzzer stops and the warning lamp goes off.
4. If the driver/passenger seat belt is fastened during the warning operation, the buzzer stops but
the warning lamp blinks for the remaining time of the period.
5. If the driver/passenger seat belt signal changes to "unfastened" from "fastened" with IGN1 ON,
the driver/passenger seat belt warning lamp comes on and the buzzer sounds again for 0.6
seconds.
But, if the condition for seat belt reminder operation is met during the warning operation, the
warning operation stops and the seat belt reminder function is activated.
03-27
8710-01