SSANGYONG Korando 2012 Manual page 663

(2) Ignition status change
1. The ignition status is changed to OFF, ACC ON, IGN ON and engine cranking by one
START/STOP button.
2. The SKM cuts the power for IGN2 and ACC relays while the engine is cranking as cutting the
electric load is necessary.
3. The SKM monitors the brake pedal status through the hardware signals.
4. The ignition status change is available when the engine START/STOP button is pressed.
5. The SKM uses the EMS (engine condition) and ABS/ESP (FR vehicle speed) signals sent through
the P-CAN bus (High Speed CAN).
6.
When the smart key battery is discharged and the driver inserts the smart key into the immobilizer
slot in emergency mode, the smart key verification is performed if the brake or START switch is
7. pressed before the ignition status is changed (ACC ON, IGN ON).
Ignition status change during driving
- When the engine START/STOP switch is pressed for 3 sec. or more at more than 3 km/h,
the ignition status is changed from IGN to ACC.
If the engine START/STOP switch is pressed again, the ignition status is changed from
ACC to IGN.
- The 4 vehicle speeds are abnormal (CAN signal timeout, abnormal signal):
If the engine START/STOP switch is pressed for 3 sec., the ignition status is changed from
IGN to ACC. If the switch is pressed again, the ignition status is changed from ACC to
OFF (DTC set).
8.
The SKM changes the ignition status as follows:
04-21
8712-03