SSANGYONG Korando 2012 Manual page 352

02-6
3. GUIDELINES ON ENGINE SERVICE
G20DF engine is for FF (Front Engine Front Drive) type vehicle. Therefore, there are some
deferent maintenance and repair works compared to the engine for FR (Front Engine Rear Drive)
type vehicle.
For safe and correct works, you must observe the working procedures and instructions in this
manual. And, use the designated tools as follow:
: Power train mounting stand / Engine hanger / Engine stand / Heavy duty engine jack.
▶ Cautions before service works
- G20DF engine is FF (Front Engine Front Drive) type engine, and the engine and
transmission are integrated in a same module. Remember that there are many differences
compared to conventional engine in FR (Front Engine Rear Drive) type SUV vehicle.
To remove the engine, use the dedicated equipments such as engine jack, transmission
jack, engine stand and engine crane (1 ton).
- To prevent the engine from abruptly starting during service in engine compartment, never
allow anybody to stay in the vehicle.
- Make sure to disconnect the negative (-) cable from the battery to prevent any damage to
electric systems.
- Make sure to clean the working area and to prepare the necessary tools before service
works.
- Always place the ignition switch to OFF position if not required. Otherwise, there could be
unexpected damage to electric devices or personal injuries due to short-circuit..
- To prevent the foreign material from entering into the fuel injection system, completely seal
the inlets of HP pump, fuel hoses and high pressure pipes.
- Do not remove the engine while supporting the oil pan with a jack.
▶ Lifting up the vehicle
- Before lifting up the vehicle with a lift, correctly support the lifting points.
- To prevent the vehicle from rolling down, put the chocks under the tires (when using a 4-
post lift).
- Make sure to support the correct lifting points (when using a 2-post lift).