SSANGYONG Korando 2012 Manual page 839

01-8
2. MOUNTING LOCATIONS (CHASSIS)
HECU for ABS
Moto
HU (Hydraulic Unit)
The HECU (Hydraulic & Electronic Control Unit) determines the slip conditions of vehicle wheels
by calculating each wheel's speed and the increment/decrement of speed based on the
information detected by the sensors, and controls the pumping and boosting/reducing/keeping
pressure by operating the valve and motor of HECU.
EPS unit
Connector to
Motor
vehicle (8P)
angle (8P)
Motor power (3P)
The ECU controls the electric power
steering system depending on the
driving conditions, based on the signals
from the torque and angle sensor.
Fuse for vehicle with EPS
The vehicle with EPS has EPS fuse
(80A) mounted to the positive (+)
terminal of the battery not in the fuse
box.
HECU (Hydraulic & Electronic Control Unit)
ECU (Electronic
Control Unit)
Battery (2P)
Torque angle
sensor (8P)
Fuse for EPS
The steering wheel angle sensor is mounted
between the steering column and the steering
column shaft. It is commonly used by the ESP
(Electronic Stability Program) system. And it receives
signals of the steering wheel angle sensor from the
ESP HECU (Hydraulic & Electronic Control Unit).
HECU for EPS
Moto
HU
(Hydraulic Unit)
Steering wheel angle sensor (SWAS)
ECU (Electronic
Control Unit)