SSANGYONG Korando 2012 Manual page 121

01-20
4. Install the ball bearing on the main bolt.
5. Tighten the main nut.
6. Slowly release the injector by turning it
counterclockwise with a torque wrench and
socket (32 mm).
To avoid any damage to cylinder head
and head cover, keep the specified
tightening torque.
To avoid the damage to injector and
engine, the lifting should be below 15 mm.
Maximum lifting: 15 mm
7. Release the other injector on same clamp
with same manner, and remove two
injectors with the clamp.