SSANGYONG Korando 2012 Manual page 506

6. INSPECTION - DARK CURRENT
- Perform the basic inspection.
1) When Using Multi-tester
Setting up the tester
▶
Preparation
▶
1. Disconnect the negative cable from the battery.
2. Set up the ammeter as shown in the figure above.
Connect the "+" probe to ground wiring and "-"probe to "-"terminal of battery.
▶ Inspection
1.
Measure the current while removing the fuses one by one. If the current drops sharply when a
certain fuse is removed, inspect the affected circuit.
Specified value
below 0.05A
14-11
0000-00