Table of Contents
Advertisement
04-30
*
Ignition status change
(OFF ->ACC) / (OFF ->IGN)/(ACC ->IGN) / (IGN -> engine ON)
-
If above conditions are met again, the SKM re-verifies the transponder and sends the
verification status for another 10 sec.
-
When the ignition status is changed by a smart key verification while the transponder
verification is processed, the SKM sends the signal for [transponder verification fail], and
sends the smart key verification status for 10 sec.
(6) Transmission position warning
When the gear selector lever is in a position other than P or N with IGN ON and engine started,
the SKM sends the [gear position warning] signal to the instrument cluster through the BCAN
for up to 10 sec. until the operating conditions are deactivated.
▶
Transmission position warning deactivation
-
When re-attempting to start with IGN1 ON and transmission in P or N
(7) SKM error alert
The SKM sends the SKM error alert signal to the instrument cluster through the BCAN for up to
10 sec. when an in ignition status related error or passive entry system error occurs.
▶
SKM error transmission conditions
When any of the following errors is detected and a DTC is set, the SKM sends the error alert
signal for 10 sec.
1.
B+ (power) low voltage
2.
B+ (logic) low voltage
3.
ACC ON fail
4.
ACC OFF fail
5.
IGN1 ON fail
6.
IGN1 OFF fail
7.
IGN2 ON fail
8.
IGN2 OFF fail
9.
Short circuit in START switch
The SKM sends the corresponding signal only once for 10 sec. when any of the above errors is
detected with IGN OFF/ON. It sends the signal again when a new error occurs.
Hide quick links:
Advertisement
Chapters
Table of Contents
