Table of Contents
Advertisement
02-4
When inspecting the airbag system, make sure to use a diagnostic device, not a circuit tester.
-
Make sure a connector is connected
securely. Loose connection results in
malfunction.
-
When disconnecting a connector equipped
with a lock, press it down to the direction in
the below figure.
-
When checking voltage or continuity of the
connector terminal with a circuit tester,
connect the tester probe to the terminal at
the harness side. For a sealed type
connector, connect the probe to the
terminal through the hole in the rubber cap
of the wiring. Take care not to damage the
insulation of the wires. Insert the probe until
it contacts the terminal completely.
Hide quick links:
Advertisement
Chapters
Table of Contents
