SSANGYONG Korando 2012 Manual page 854

2) Equipment
- Korando is FF (Front Engine Front Drive) type vehicle, and engine and powertrain system are
integrated into a module. Therefore, 2-post lift and general equipment are necessary when
working on the engine and transmission.
- Major equipment: Engine and transmission jack, Engine stand, Engine crane, Transmission
jack, Engine hanger
Remove the engine and transaxle as a set.
- Manual transaxle: Transaxle can be separated after removing the front module (sub frame,
engine and transaxle).
- Automatic transaxle: Transaxle can be separated after removing the sub frame.
3) General Instructions
(1) Before lifting up the vehicle with a lift, correctly support the lifting points.
(2) When using a jack, park the vehicle on a level ground and place the wheel chocks under the
tires. Position the jack under the frame and lift up the vehicle and then support with chassis
stand before service work.
(3) Make sure to disconnect the negative (-) cable from the battery to prevent any damage to
electric systems.
(4) If you have to work on vehicle, cover the seats and floor with protection covers to avoid any
damage and contamination.
(5) Brake fluid and anti-freeze can damage the painted surface of body. So carefully handle
them during service work.
(6) To improve the efficiency of service work, use only recommended and specified tools.
(7) Use only Ssangyong genuine spare parts.
(8) Never reuse the cotter pin, gasket, O-ring, oil seal, lock washer and self-locking nut.
Replace them with new ones. If reused, normal functions cannot be maintained.
(9) Store the disassembled parts as a set based on disassembly order and unit.
(10) Pay particular attention not to miss or mix the fasteners.
(11) If necessary, especially for inspection, clean the removed parts completely.
(12) Apply the oil or grease on the running and sliding surfeces before installation. Use the
specified sealant and gasket to prevent leakage if necessary.
(13) Tighten the fasteners to the specified tightening torque.
(14) As a final stage of service work, check if the serviced system is working properly and the
problem has been eliminated clearly.
0000-00
Engine crane
Engine stand
01-23