Mazda RX-8 Manual page 375

10. Turn the ignition switch to the ON position for 10 min and then operate the fuel pump.
11. Measure the fuel pressure 5 min after turning the ignition switch to the LOCK position.
If not within the specification, inspect the following:
•
Fuel filter clogging (low-pressure side and high-pressure side)
Fuel line clogging or leakage
Standard
200 kPa {2.0 kgf/cm
o
12. Disconnect the jumper wire.
13. Follow the before repair procedure and practice the fuel line safety procedure. (See BEFORE REPAIR
PROCEDURE .)
14. Disconnect the SST .
15. Connect the quick release connector. (See QUICK RELEASE CONNECTOR
REMOVAL/INSTALLATION .)
16. Inspect all parts by performing the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR
PROCEDURE .)
2
, 29 psi} or more
(w) Engine Specifications
Page 138