Mazda RX-8 Manual page 386

Hide thumbs Also See for RX-8:

Table of Contents

3. Remove the fuel injector and fuel distributor as a single unit. (See FUEL INJECTOR

REMOVAL/INSTALLATION .)

4. Fix the fuel injector to the fuel distributor with a wire or the equivalent.

5. Connect the fuel hose.

6. Connect the negative battery cable.

Shorting the wrong terminal of the check connector may cause malfunctions. Make sure to short

only the specified terminal.

7. Ground the check connector terminal F/P using the jumper wire.

8. Turn the ignition switch to the ON position and operate the fuel pump.

9. Tilt the fuel injector at an angle of 60° ° ° ° to inspect for leakage.

Engine Specifications

Troubleshooting