Table of Contents
Advertisement
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
7.13.3 Setting Service Reporting
Write
command
Function
Response
Note:
If no parameters of this command are set, AT+CR= considers the previously set values valid
for various parameters.
7.14 AT+CRC - Command for Setting the Cell Result
Codes
The AT+CRC command sets whether the caller ID display follows the extended
format.
7.14.1 Querying the Supported Settings for the Cell Result Codes
Test
command
Function
Response
Parameter description
<mode>: integer.
+CRING: <type>
<type>: string. Table 7-2 describes the values of <type>.
Table 7-2 Values of <type>
Value
"REL ASYNC"
Issue 02 (2010-11-23)
AT+CR=[<mode>]
Sets service reporting.
In case of successful execution: <CR><LF>OK<CR><LF>
In case of an error: <CR><LF>ERROR<CR><LF>
AT+CRC=?
Queries the settings for the cell result code in caller ID display.
In case of successful execution:
<CR><LF>+CR: (list of supported <mode>s) <CR><LF>
<CR><LF>OK<CR><LF>
In case of an error: <CR><LF>ERROR<CR><LF>
0 (default value): does not follow the extended format. In this case, the reporting
format is RING.
1: follows the extended format. In this case, the reporting format is as follows:
Description
Asynchronous and non-transparent transmission
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Call Control
69
Advertisement
Table of Contents
