Reading The Current Settings For Event Reporting; Setting The Event Reporting Mode; At+Cind - Command For Controlling Indication Events - Huawei MG323 At Command Interface Specification

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
<disp>: integer; enables display event reporting, which is not supported currently.
0
<ind>: integer; indicates event reporting.
<bfr>: integer; clears the buffer.
0

3.1.2 Reading the Current Settings for Event Reporting

Read
command
Function
Response

3.1.3 Setting the Event Reporting Mode

Write
command
Function
Response
Note:
If no parameters of this command are set, AT+CMER= considers the previously set values
valid for various parameters.
3.2 AT+CIND - Command for Controlling Indication
Events
The AT+CIND command controls the mode of reporting indication events for certain
functions, including battery power level, signal strength, service availability, unread
short message indicator, and full short message storage.
Issue 02 (2010-11-23)
Reports the event.
0 (default value): disables event reporting.
1: enables event reporting; +CIEV:<ind>,<value>, in which <ind> indicates the
event of the indicator, which is a character string.
2: enables event reporting; +CIEV: <ind>,<value>, in which all events occur
directly between the TE and TA.
Clears the buffer.
AT+CMER?
Reads the current settings for event reporting.
<CR><LF>+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr><CR><LF>
<CR><LF>OK<CR><LF>
AT+CMER=[<mode>[,<keyp>[,<disp>[,<ind>[,<bfr>]]]]]
Sets the event reporting mode.
In case of successful execution: <CR><LF>OK<CR><LF>
In case of an error: <CR><LF>ERROR<CR><LF>
In case of an error related to the MT: <CR><LF>+CME ERROR:
<err><CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Status Control
29