Reading The Character Set Of The Te; Setting The Character Set Of The Te; Table 2-8 Character Set Of The Ms - Huawei MG323 At Command Interface Specification

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification

Table 2-8 Character set of the MS

Value
"GSM"
(default value)
"UCS2"
"IRA"
Note:
If <chset> is set to "GSM", an error may occur on software flow control (XOFF/XON).

2.12.2 Reading the Character Set of the TE

Read
command
Function
Response

2.12.3 Setting the Character Set of the TE

Write
command
Function
Response
Note:
Issue 02 (2010-11-23)
Description
GSM 7bit coding (GSM 03 .38 subclause 6.2.1)
16-bit universal multiple-octet coded character set (ISO/IEC10646
[32]); the UCS2 string is converted into a hexadecimal number
ranging from 0000 to FFFF, for example, "004100620063", which is
equivalent to three 16-bit characters. The ASCII values in decimal
mode are 65, 98, and 99.
International reference character set
AT+CSCS?
Reads the character set of the TE.
<CR><LF>+CSCS: <chset><CR><LF>
<CR><LF>OK<CR><LF>
AT+CSCS=[<chset>]
Sets the character set of the TE and notifies the TA of it so that the TA
can properly convert the character set between the TE and MT.
In case of successful execution: <CR><LF>OK<CR><LF>
In case of an error related to the MT: <CR><LF>+CME ERROR:
<err><CR><LF>
If the interface between the TA and TE has eight bits and the character set used by the TE
has seven bits, the most significant bit of the character set must be set to 0.
In this section, AT+CSCS= is equivalent to AT+CSCS="GSM"(<chset>="GSM").
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Configuration
23