Table of Contents
Advertisement
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
OK
9.3 AT+CGEREP - Command for Reporting GPRS Events
The AT+CGEREP command sets the unsolicited reporting of GPRS events. When
certain events occur on the GPRS MT or the network, this command can enable or
disable the sending of URC+CGEV: XXX from the MT to the TE. For the +CGEV
reporting command, refer to section 9.11 .
9.3.1 Checking the Supported GPRS Event Reporting Mode
Test
command
Function
Response
Parameter description
<mode>: numeric parameter.
<bfr>: numeric parameter.
Issue 02 (2010-11-23)
AT+CGEREP=?
Checks the supported GPRS event reporting mode.
In case of successful execution:
<CR><LF>+CGEREP: (list of <mode>s),(list of supported
<bfr>s)<CR><LF>
<CR><LF>OK<CR><LF>
In case of an error during command execution:
<CR><LF>ERROR<CR><LF>
In case of an error related to the MT: <CR><LF>+CME ERROR:
<err><CR><LF>
0: buffers the URCs on the MT. If the buffer is full, the oldest URC is discarded
and URCs are not sent to the TE.
1: When the MT-TE link is reserved (for example, in online data mode), URCs
are discarded. Otherwise, URCs are directly forwarded to the TE.
2: When the MT-TE link is reserved (for example, in online data mode), URCs
are buffered. After the MT-TE link is available, all URCs are sent to the TE.
Otherwise, URCs are directly forwarded to the TE. If the buffer is full, the oldest
URC is discarded.
0: When the entered value of the <mode> parameter is 1 or 2, the URC buffer
defined by this command is cleared.
1: When the entered value of the <mode> parameter is 1 or 2, the URC buffer
defined by this command is fully sent to the TE (OK is returned before sending)
and the buffer is cleared.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Data Services
114
Advertisement
Table of Contents
