Reading The Current Indication Status; Setting Whether To Report Indication Events - Huawei MG323 At Command Interface Specification

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
<indDescr>
"roam": roaming indicator.
"smsfull": short message
storage full indicator.
"rssi": receive signal strength
indicator.

3.2.2 Reading the Current Indication Status

Read
command
Function
Response

3.2.3 Setting Whether to Report Indication Events

Write
command
Function
Response
Parameter description
<mode>: integer. This parameter controls whether to report a single indication event.
0: deregisters indication event and disables event reporting.
1 (default value): registers indication event and enables event reporting.
Issue 02 (2010-11-23)
<indValue>
0: registers with the home network or does not
register with any network.
1: registers with the roaming network.
0: The short message storage media is not full.
1: The short message storage media is full.
0: ≤ -112 dBm
1–4: The strength interval is 15 dBm.
5: ≥ -51 dBm
99: unknown or unmeasurable.
AT+CIND?
Reads the current indication status.
<CR><LF>+CIND: <indValue>[,<indValue>[, ...]] <CR><LF>
<CR><LF>OK<CR><LF>
AT+CIND=<mode>[,<mode>[,<mode>...]]
Sets whether to report indication events.
In case of successful execution: <CR><LF>OK<CR><LF>
In case of an error: <CR><LF>ERROR<CR><LF>
In case of an error related to the MT: <CR><LF> +CME ERROR:
<err><CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Status Control
31