HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
3.4.2 Reading the Current Radio Network
Read
command
Function
Response
3.4.3 Setting the Radio Network to Be Registered
Write
command
Function
Response
3.5 +CIEV – Command for Indicating the Status Change
When the status of relevant event set by using AT+CIND or AT^SIND is changed, the
MT unsolicitedly reports +CIEV.
URC1
URC2
Function
Parameter description
Refer to the parameter descriptions of AT+CMER, AT+CIND, and AT^SIND
commands.
Issue 02 (2010-11-23)
AT+WS46?
Reads the current radio network.
<CR><LF><n><CR><LF>
<CR><LF>OK<CR><LF>
AT+WS46=[<n>]
Sets the radio network to be registered.
In case of successful execution: <CR><LF>OK<CR><LF>
In case of an error related to the MT: <CR><LF>+CME ERROR:
<err><CR><LF>
Reports with the standard format.
<CR><LF>+CIEV: <indDescr>,<indValue>1[,<indValue>2]<CR><LF>
Reports with the "nitz" indication format.
<CR><LF>+CIEV: <indDescr>,<nitzUT>,<nitzTZ>,<nitzDST><CR><LF>
Indicates that the status of the event registered by using AT+CMER is
changed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Status Control
36