Ats4 - Command For Setting The Response Format Character; Querying The Current Format Character - Huawei MG323 At Command Interface Specification

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
013
OK
Example 2:
Set the command line ending character.
ATS3=13
OK
16.3 ATS4 – Command for Setting the Response Format
Character
This command sets the response format character. This character is sent by the TE
and is involved in the head, tail, and end tags of the result code and information
response. If the S4 character in a command line is changed, the result code in this
command line uses the new S4 character immediately.

16.3.1 Querying the Current Format Character

Read
command
Function
Response
Parameter description
<n>: integer, which indicates the ASCII code of the response format character. Value
range: 0–127. Default value: 10.
Issue 02 (2010-11-23)
ATS4?
Queries the current response format character.
In case of successful execution:
<CR><LF><n><CR><LF><CR><LF>OK<CR><LF>
In case of an error during command execution:
<CR><LF>ERROR:<CR><LF>
In case of an error related to the MT: <CR><LF>+CME ERROR:
<err><CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Other Commands
206