Table 2-10 Values Of The < Tcpwithurc > Parameter; Table 2-11 Values Of The <Udri> Parameter; Table 2-12 Values Of The <Uri> Parameter - Huawei MG323 At Command Interface Specification

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
<tcpMr>: integer, which indicates the maximum number of retransmissions (MR). The
default value is 10.
1... 30
<tcpOt>: integer, which indicates the duration for link disabling. The default value is
6000.
1...6000 Duration (in seconds) to be waited for disabling a link when a TCP/IP data
packet is not acknowledged.
<tcpWithUrc>: string, which indicates whether the internet service command follows
the unsolicited reporting mode or polling mode. This parameter controls whether
^SISR, ^SISW, and ^SIS are unsolicitedly reported.
Table 2-10 Values of the < tcpWithUrc > parameter
Value
"on" (default value)
"off"
<udri>: indicates RING reporting in data mode. This parameter controls the reporting
string in TA-TE connection hold state (such as CS data service, GPRS data service,
and AT command execution).
Table 2-11 Values of the <udri> parameter
Value
"on"
"off" (default value)
<uri>: string, which indicates the URC mode of the RING pin.
Table 2-12 Values of the <uri> parameter
Value
"local" (default
value)
"off"
Issue 02 (2010-11-23)
Maximum number of times for retransmitting a TCP/IP data packet.
Description
Enables unsolicited reporting related to the internet service
command.
Disables unsolicited reporting related to the internet service
command.
Description
Reports RING. This value is set by <urat> and <uri>.
Reports BREAK.
Description
Reports RING.
Does not report RING.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Configuration
25