At+Cfun - Command For Setting The Work Mode; Querying The Supported Work Modes; Table 2-6 List Of Work Modes - Huawei MG323 At Command Interface Specification

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
<n>: integer; ATE is equivalent to ATE0.

2.8 AT+CFUN - Command for Setting the Work Mode

2.8.1 Querying the Supported Work Modes

Test command
Function
Response
Parameter description
<fun>: integer, which indicates the work mode to be set on the board. The values are
described in the following table.

Table 2-6 List of work modes

<fun>
0
1 (default
value)
5
6
7
Issue 02 (2010-11-23)
0: disables echo.
1 (default value): enables echo.
AT+CFUN=?
Queries the work modes supported by the module.
<CR><LF>+CFUN: (list of supported <fun>s), (list of supported
<rst>s)<CR><LF>
Function Description
Non-cyclic sleep mode
No power saving
Cyclic sleep mode. After data
processing is complete upon wakeup,
the system stays in IDLE state for 2s.
Cyclic sleep mode. After data
processing is complete upon wakeup,
the system stays in IDLE state for 10
minutes. For other tasks, after
message processing is complete and
the system is idle again, the system
automatically enters SLEEP mode
again.
Cyclic sleep mode. After data
processing is complete upon wakeup,
the system stays in IDLE state for 2s.
For other tasks, after message
processing is complete and the
system is idle again, the system
automatically enters SLEEP mode
again.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Configuration
Remarks
Upon wakeup, the system is
switched to the state of no power
saving.
During wakeup, the serial port
can work properly.
16