Reading The Currently Registered Network And Operator Information; Setting The Current Operator Information; Examples - Huawei MG323 At Command Interface Specification

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification
8.2.2 Reading the Currently Registered Network and Operator
Information
Read
command
Function
Response

8.2.3 Setting the Current Operator Information

Write
command
Function
Response
Note:

8.2.4 Examples

Example 1:
Obtain the list of available operator information.
AT+COPS=?
+COPS: (2,"CC 460 NC 09",,"46009"),(3,"CHN-CUGSM",,"46001"),(3,"CHINA
MOBILE",,"46000"),,(0-4),(0,2)
OK
Example 2:
Issue 02 (2010-11-23)
AT+COPS?
Reads the currently registered network and operator information.
In case of successful execution:
<CR><LF>+COPS: <mode>[,<format>[,<oper>]]<CR><LF>]
<CR><LF>OK<CR><LF>
In case of an error during command execution:
<CR><LF>ERROR<CR><LF>
In case of an error related to the MT during command execution:
<CR><LF>+CME ERROR: <err><CR><LF>
AT+COPS=<mode>[,<format>[,<oper>]]
Sets the current operator information.
In case of successful execution: <CR><LF>OK<CR><LF>
In case of an error during command execution:
<CR><LF>ERROR<CR><LF>
In case of an error related to the MT during command execution:
<CR><LF>+CME ERROR: <err><CR><LF>
In automatic network searching mode, only the <mode> parameter is valid and other
parameters are omitted.
When the set operator information does not exist or is unavailable, the CME ERROR is
returned.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Commands for Network Services
77