Replace Moving End Brackets - JLG 600SC Service And Maintenance Manual

SECTION 4 - BOOM & PLATFORM
2. Parts used: Bracket Center Pin and Center Pin Snap Ring.
3. Take new bracket and install bracket center pin and
snap ring. Repeat on other bracket if replacing it.
NOTE: Ensure snap rings are seated in pin groove and closed
properly.
Correct
4-32

Replace Moving End Brackets

REPOSITION CABLES AND HOSES. KEEP COVERED DURING GRINDING TO PRE-
VENT DAMAGE.
Incorrect
1. Remove existing pins and center rivet. Remove rivet as
shown in link removal instructions on page 4-25. Repeat
on other bracket if replaced.
3121776