Input/Output Of Machine Data And Operating Data - Siemens WF 725 Planning Instructions

Description of the functions
2.3

Input/Output of Machine Data and Operating Data

2.3.1 Description of the FB 205
The function block supplies the following functions:
• Input/output of MD (Axis 1...21).
• Input/output of reference point feed rates (Axis 1...21).
• Input/output of feed rate 1 and 2 for the operating submode Jog.
• The displays are selected with a menu.
• The menu is selected over the PLC-key of the SINUMERIK 3 operator panel.
• The user sets the desired axis number over the parameter ACHS. If the mask operating
data is selected, then the displayed values are updated automatically as soon as the axis
number is changed. The values are not changed when a number is not valid, an error
message is read out as a parameter.
Menu output on the screen of SINUMERIK 3
# # # # # # # # # # # # # #
0 S T A T U S
2 - 12
- 0 R U E C K - M E L D U N G
- 1 W F
- 2 W F
©
Siemens AG 1990 All Rights Reserved
WF 725/WF726 (PJ – NC Auxiliary axis and tool magazine for SINUMERIK 3GA4)
M A - D A T E N
B E T R - D A T E N
08.90
6ZB5 440-0JB02