Setting The Dhcp Mode - SMC Networks WUSB32 - annexe 2 Manual

Configuring Dynamic Host Configuration Protocol
Note:
5. Click [Submit]. A page appears to confirm your changes, and
then the program returns to the [Dynamic Host Configuration
Protocol (DHCP) Relay Configuration] page.
6. Follow the instructions in Setting the DHCP Mode to set
the DHCP mode to DHCP Relay.

Setting the DHCP Mode

You must enable the appropriate DHCP mode to activate
your DHCP relay or DHCP server settings.
Follow these instructions to set the DHCP mode:
1. Click the [LAN] tab, and then click [DHCP Mode] in the
task bar. The [Dynamic Host Configuration Protocol (DHCP)
Configuration] page appears.
2. From the [DHCP Mode:] drop-down list, choose [DHCP Server],
[DHCP Relay], or [None]. If you choose [None], your LAN
computers must be configured with static IP addresses.
3. Click [Submit].
4. Click the [Admin] tab, and then click [Commit & Reboot]
in the task bar.
5. Click [Commit] to save your changes to the permanent
memory.
54
You can also delete an interface from the table
by clicking in the right column.
Figure 15. DHCP Configuration Page