Avaya J100 Series Installing page 64

Configuring the phone using web interface
Name
SIP Timer T4
INVITE Response Timeout
Failed Session Removal
Timer
Outbound Subscription
Duration Request
Controller Search Interval
Active subscription wait
time for "avaya-cm-
feature-status"
Remote Data Source initial
retry time
Remote Data Source
maximum retry time
Remote Data Source initial
retry attempts
December 2018
Description
The default value is 4,000 milliseconds.
Specifies the maximum duration in milliseconds for which a message
remains in the network.
The valid value is an integer from 2,500 to 60,000.
The default value is 5,000 milliseconds.
Specifies the maximum number of seconds that the phone waits for
another response after receiving a SIP 100 Trying response.
The valid value is an integer from 30 to 180.
The default value is 60 seconds.
Specifies the time in seconds to automatically remove a failed call session.
The valid value is an integer from 5 to 999.
The default value is 60 seconds.
Specifies the Outbound subscription request duration in seconds.
The valid value is an integer from 60 to 31,53,600.
The default value is 86,400 seconds.
Specifies the time in seconds that the phone waits to complete the
maintenance check for monitored controllers.
The valid value is an integer from 4 to 3,600.
The default value is 16 seconds.
Specifies the time in seconds that the phone waits to validate an active
subscription when it subscribes to the avaya-cm-feature-status package.
The valid value is an integer from 16 to 3,600.
The default value is 60 seconds.
Specifies the number of seconds that the phone waits for the first time
before trying to contact the PPM server again after a failed attempt. Each
subsequent retry is delayed by double the previous delay time.
The valid value is an integer from 2 to 60.
The default value is 2 seconds.
Specifies the maximum delay interval in seconds after which the phone
stops to contact the PPM server.
The valid value is an integer from 2 to 3,600.
The default value is 600 seconds.
Specifies the number of attempts the PPM adaptor must try to download
from PPM before it stops connecting to the PPM server.
The valid value is an integer from 1 to 30.
The default value is 15 attempts.
Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
Table continues...
64