Avaya J100 Series Installing page 62

Configuring the phone using web interface
Name
Send DTMF
OPUS Payload
G.726 Payload
DTMF Payload
RTP
Play Tone till RTP
Symmetric RTP
RTCP_XR
SRTP
December 2018
Description
The options are:
• Disable
• Enable (default)
Specifies whether the phone sends DTMF tones in-band as regular audio,
or out-of-band using RFC 2833 procedures.
The options are:
• In-band
• Out-of-band (default)
Dynamically specifies the RTP payload type to be used for OPUS codec.
The parameter is used when the media request is sent to the far-end in an
INVITE or 200 OK when INVITE with no Session Description Protocol
(SDP) is received.
The valid value is an integer from 96 to 127. The default value is 116.
Specifies the RTP payload type to be used for the G.726 codec.
The valid value is an integer from 96 to 127. The default value is 110.
Specifies the RTP payload type to be used for RFC 2833 signaling.
The valid value is an integer from 96 to 127. The default value is 120.
Specifies whether the locally generated ringback tone stops when SDP is
received for an early media session, or whether it continues until RTP is
actually received from the far-end party.
The options are:
• Yes (default)
• No
Specifies whether the phone must receive RTP if the UDP source port
number is not same as the UDP destination port number.
The options are:
• Disable
• Enable (default)
Specifies whether VoIP Metrics Report Block as defined in RTP Control
Protocol Extended Reports (RTCP XR) (RFC 3611) is sent as part of the
RTCP packets to a remote peer or an RTCP monitoring server.
The options are:
• Yes
• No (default)
Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
Table continues...
62