Ethernet Settings Field Descriptions - Avaya J100 Series Installing

• Ethernet Interface
4. Click one of the following:
• Save: To save the configuration changes.
• Reset to Default: To revert to the default values.
Related links

Ethernet settings field descriptions

Ethernet settings field descriptions
Name
IP Configuration
IP Mode
Dual Mode Operation
Preference
Extended Re-bind Time
IPv4 Configuration
Use DHCP
Continue to use DHCP
information after lease expiry
December 2018
on page 47
Description
Specifies the IP mode.
The options are:
• IPv4 only
• Dual mode (default)
• IPv6 only
Specifies the preference of the operation mode.
The options are:
• IPv4 (default)
• IPv6
Specifies the time in seconds for which you can continue to use the
assigned IP address after the DHCP lease expires.
The valid value is an integer from 0 to 999. The default value is 60
seconds.
Specifies whether to enable/disable DHCP as a source in IPv4 network.
The options are:
• Yes (default): To assign the IPv4 address automatically to your
phone.
• No: To assign the IPv4 address manually to your phone.
Note:
To assign the IP address manually, you must also configure the IP
Address, Subnet Mask, and Gateway IP Address fields
manually.
Specifies whether the DHCP information can be used after the lease
expires.
Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
Configuring Ethernet settings
Table continues...
47