Avaya J100 Series Installing page 209

Parameter name
DOT1XEAPS
DOT1XSTAT
DSCPAUD
DSCPAUD_FL
DSCPAUD_FO
DSCPAUD_IM
DSCPAUD_PR
December 2018 Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
List of configuration parameters
Default Description
value
• 2: EAPOL multicast pass-through
disabled.
MD5 Specifies the authentication method
to be used by 802.1X.
Valid values are MD5, and TLS.
0 Specifies the 802.1X supplicant
operating mode.
Value Operation:
• 0: Supplicant disabled.
• 1: Supplicant enabled, but
responds only to received unicast
EAPOL messages.
• 2: Supplicant enabled; responds
to received unicast and multicast
EAPOL messages.
46 Specifies the layer 3 Differentiated
Services (DiffServ) Code Point for
audio frames generated by the
phone.
Valid values are from 0 to 63.
This parameter can also be set
through the LLDP, which overwrites
any value set in this file.
43 Specifies the DSCP value for flash
precedence or priority level voice
call.
Valid values are from 0 to 63.
41 Specifies the DSCP value for flash
Override precedence or priority
level voice call.
Valid values are from 0 to 63.
45 Specifies the DSCP value for
immediate precedence or priority
level voice call.
Valid values are from 0 to 63.
47 Specifies the DSCP value for
priority precedence or priority level
voice call.
Valid values are from 0 to 63.
Table continues...
209