Tlv Impact On System Parameter Values - Avaya J100 Series Installing

TLV impact on system parameter values

System parameter
name
PHY2VLAN
L2QVLAN and L2Q IEEE 802.1 VLAN
L2Q, L2QVLAN,
L2QAUD,
DSCPAUD
L2Q, L2QVLAN
December 2018
TLV name Impact
IEEE 802.1 Port The value of the PHY2VLAN parameter on the phone is
VLAN ID configured from the value of the Port VLAN identifier in the
TLV.
The value is changed to the TLV VLAN Identifier. L2Q is set to
Name 1 (ON).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
VLAN Name TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The current value of L2QVLAN was set by a TIA LLDP MED
Network Policy TLV.
• The VLAN name in the TLV does not contain the substring
"voice" in lower-case, upper-case or mixed-case ASCII
characters anywhere in the VLAN name.
TIA LLDP MED L2Q - set to 2 (off) if T (the Tagged Flag) is set to 0 and to 1
Network Policy (on) if T is set to 1.
(Voice) TLV
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
TIA LLDP MED L2Q - set to 2 (off) if T (the Tagged Flag) is set to 0 and to 1
Network Policy (on) if T is set to 1.
(Voice Signaling)
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
Configuration through LLDP
Table continues...
107