Avaya J100 Series Installing page 26

Phone installation
Parameter Name
WEP_KEY_LEN
WLAN_PASSWORD
WEP_KEY_1 to WEP_KEY_4
WLAN_WPA2E_EAP_METHOD
WLAN_WPA2E_IDENTITY
December 2018
Default Value
128 bit
N/A
N/A
PEAP
N/A
Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
Description
Value operation:
• 0: Disable
• 1: Enable
Specifies the length of the WEP
key.
Value operation:
• 40 bit
• 64 bit
• 128 bit
Specifies the pre-configured Wi-Fi
network password. This
parameter is applicable if the
WIFISTAT is enabled and
WLAN_SECURITY is wpa2psk,
or WLAN_SECURITY is wpa2e,
WLAN_WPA2E_EAP_METHOD
is PEAP and
WLAN_WPA2E_EAP_PHASE2 is
MSCHAPV2.
The password must be from 8 to
63 characters. Note that the
space and ASCII 0x20 are not
supported.
Specifies the name of the WEP
key.
The name of the 40 bit key and
128 bit key are of 10 hex digits
and 26 hex digits respectively.
Specifies the pre-configured
802.1x EAP method. This
parameter is applicable if
WIFISTAT parameter is enabled
and WLAN_SECURITY is set as
wpa2e.
Value operation:
• PEAP
• TLS
Specifies the 802.1x name of pre-
configured Wi-Fi network. This
parameter is applicable if
Table continues...
26