Debugging - Avaya J100 Series Installing

Configuring the phone using web interface
(^), ampersand (&), asterisk (*), underscore(_), minus (-), plus (+), equal (=), back quote (`), pipe
(|), back slash (\), parenthesis (()), braces ({}), brackets ([]), colon (:), semicolon (;), single quote
('), lesser than (<), greater than (>), comma (,), period (.), question mark (?), forward slash (/).
Procedure
1. Log in to the web interface by using your username and current password.
2. In the navigation pane, click Password.
3. In the Web Admin Password section, do the following:
a. Enter your current password in the Current Password field.
b. Enter your new password in the New Password field.
c. Re-enter your new password in the Confirm Password field.
d. Click Save.
4. In the Phone Administration Menu Password section, do the following:
a. Enter your web administrator password in the Web Administrator Password field.
b. Enter your new password in the New Password field.
c. Re-enter your new password in the Confirm Password field.
d. Click Save.

Debugging

About this task
Avaya J100 Series IP Phones display the details of the configuration fields in the Description
section.
Procedure
1. Log in to the web interface as an administrator.
2. In the navigation pane, click Debugging.
3. Configure the fields in the following areas:
• Log
• SNMP
• RTCP Monitoring
• Phone Report
• SSH
• SLA Monitor
• Other
December 2018 Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
84