Avaya J100 Series Installing page 255

Parameter name
RTCPMON
RTCPMONPERIOD
RTCPMONPORT
RTP_PORT_LOW
RTP_PORT_RANGE
S
SCEPPASSWORD
December 2018 Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
List of configuration parameters
Default Description
value
Null Specifies the IP or DNS address for
the RTCP monitor.
You can set this parameter only if
the environment is not an Avaya
environment. The values can range
from 0 through 255 characters.
5 Specifies the interval, in seconds,
for sending out RTCP monitoring
reports. Valid values are from 5 to
30 seconds.
5005 Specifies the RTCP monitor port
number.
You can set this parameter only if
the environment is not an Avaya
environment. The values can range
from 0 through 65535. Default is
5005.
Specifies the lower limit of the UDP
port range to be used by RTP or
RTCP and SRTP or SRTCP
connections.
The values can range from 1024
through 65503.
Specifies the range or number of
UDP ports available for RTP or
RTCP and SRTP or SRTCP
connections
This value is added to
RTP_PORT_LOW to determine the
upper limit of the UDP port range.
The values can range from 32
through 64511.
$SERIALN Specifies the password to be
O included in the change password
attribute of an SCEP certificate
request.
Values can contain 0 to 32 ASCII
characters (50 ASCII characters.
If the value contains $SERIALNO, it
is replaced by the phone's serial
Table continues...
255