Table of Contents
Advertisement
Figure 86. Installing the internal USB card
Next steps
1.
Install the expansion card
2. Follow the procedure listed in
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Intrusion switch
Removing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Disconnect the intrusion switch cable from the connector on the rear I/O board.
2. Using a Phillips #2 screwdriver, loosen the screw on the intrusion switch module.
3. Slide the intrusion switch module out of the slot on the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
risers.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.
Installing and removing system components
107
Advertisement
Table of Contents
