Intrusion Switch Module; Removing The Front Intrusion Switch - Dell EMC PowerEdge xe7100 Installation And Service Manual

CAUTION: Be careful regarding the control panel LEDs while installing the backplane to the chassis.
2. Holding the plastic handle, slide the backplane towards the front until the chassis guide pins are secure.
Figure 72. Installing the backplane/midplane assembly
3. Replace the 24 screws on the backplane and four screws on the sides of the chassis to secure the backplane/midplane
assembly to the chassis.
4. Connect all the cables to the connectors on the backplane board.
Next steps
1. Install the drive cage.
2. Install the fan control
3. Install the fan cage.
4. Install the system fans.
5. Install the power distribution
6. Install the power supplies.
7. Install the expander module
8. Install the sleds.
9. Install all the drives.
10. Install the system cover.
11. Follow the procedure listed in

Intrusion switch module

Removing the front intrusion switch

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
66 Installing and removing enclosure components
board.
board.
After working inside the
safety instructions.
Before working inside your
system.
system.