2. Route the cable properly to prevent the cable from being pinched or crimped.
3. Press the release tabs on the fan cable connector and connect the cable to the system board.
Figure 25. Installing a cooling fan
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Intrusion switch
Remove the intrusion switch
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
Remove the air
shroud.
•
Keep the plastic scribe ready.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
62
Installing and removing system components
After you work inside your
system.
Safety
instructions.
Before working inside your
system.