Optional Idsdm Or Vflash Module; Removing The Optional Idsdm Or Vflash Card - Dell EMC PowerEdge T340 Installation And Service Manual

4 Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1 Align the M.2 SSD module at an angle with the BOSS card connector.
2 Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3 Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
Figure 61. Installing the M.2 SSD module
Next steps
1 Install the BOSS card.
NOTE: The procedure to install the BOSS card is similar to removing an expansion card.
2 Install the air shroud.
3 Follow the procedure listed in the

Optional IDSDM or vFlash module

The IDSDM or vFlash module combines the IDSDM and/or vFlash features into a single module.
NOTE: The write-protect switch is on the IDSDM or vFlash module.

Removing the optional IDSDM or vFlash card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
88 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.