Figure 80. Installing the M.2 SSD module
module connector (2)
screws (2)
modules (2)
Next steps
Install the BOSS card.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
Install the air
shroud.
Follow the procedure listed in
Optional IDSDM or vFlash module
NOTE:
The write-protect switch is on the IDSDM or vFlash module.
Removing the optional IDSDM or vFlash card
Prerequisites
Follow the safety guidelines listed in
Follow the procedure listed in
If you are replacing the IDSDM/vFlash card, remove the MicroSD cards.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Steps
Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
After working inside your
system.
Safety
instructions.
After working inside your
system.
System board jumpers and connectors
section.
Installing and removing system components
125